REMOTE SETUP
RCA RCR414BHE setup: check the revision first.
The battery-compartment revision determines the official code list. Match it before entering a code or starting a search.
Identify this remote
- Remove the battery cover and confirm the label says RCR414BHE. Record the revision printed with it.
- Install two fresh AA batteries in the marked direction.
- Turn on the device you want to control. Use RCA’s finder with that exact revision, device type and device brand.
Enter a five-digit code
- Press and hold the key for the device you are programming. The POWER key lights.
- Keep holding the device key while entering the first official five-digit code. POWER goes out after the first digit.
- After the fifth digit, keep holding the device key and inspect POWER. A lit key means the code was accepted; four blinks mean it was invalid or mistyped.
- Release the device key, aim the remote and test several controls.
- If only some controls work, repeat with the next official code. Releasing the device key early exits and retains the prior code.
Automatic search fallback
- With the device on, hold its device key and POWER until POWER comes back on steadily, then release both.
- Aim at the device. Press PLAY, wait five seconds, and repeat until the device turns off. Each press tests a batch of codes.
- Press REVERSE, waiting at least two seconds between presses, until the device turns on. If you pass the working code, press FORWARD once.
- Press STOP to save. Press EXIT to cancel without saving.
Four POWER blinks after about two minutes or after all codes have been tested means the search ended without saving a new code. The previous code remains; choose another official method instead of repeating PLAY indefinitely.
Test more than power
Check volume and mute, channel, input, navigation/menu/home and playback controls that apply to the device. Partial control means try the next official code. For a combination unit, program its parts on separate device keys when the manual calls for it.
Keep a clear line of sight, move closer and remove obstacles. These steps narrow a programming problem; they do not certify or repair the remote or the controlled device.